Edges, falls and color on a Blandon back patio
Behind most Maidencreek Township houses sits a plain slab outside the back door. Coating it well comes down to three things almost nobody asks about on the first call.

The typical Blandon patio call goes like this. The house went up in the late nineties or the two thousands, the builder poured a slab outside the back door, and twenty odd years later it is gray, a little dusty, and sitting right where everyone walks out with a plate of burgers. The owner wants it to look like part of the house. That part is easy. The bits that decide whether it still looks right in ten winters are the slab edges, the direction the water runs, and a blend picked in your own daylight. Those three are what this post is about.
A builder’s slab outside the back door
Development patios up here are usually in decent shape. They were poured flat, they were poured with the house, and most of them have never had anything on them at all. That is good news, because sound concrete means the time goes into the finish instead of into cutting out damage.
Decent still gets ground. The diamond grinder opens the surface so the base coat has a profile to bond into, and any divots or hairline cracks get filled level. On a newer slab that is normally a short list.
What a patio faces that a garage never does is a full Berks County winter with nothing over it. Roughly forty freeze and thaw cycles a season, water in the pores expanding by about nine percent each time it freezes, and five or six years of that is enough to turn a smooth slab into a flaking one. Sealing it while it is still sound is the cheapest moment you will get, and the outdoor build is specified for that exposure, not copied from a garage.
Coating the edges as well as the top
A patio set into lawn has more exposed concrete than people think. The top is the obvious part. The faces along the open sides, where the slab stands a little proud of the grass, are where water sits against the concrete and where the freeze gets its first grip, because a corner has concrete open on two faces at once.
So we wrap them. Wherever the edge is exposed, the system carries over the corner and down the face toward the soil, ground and coated the same as the top. Leave the edges bare and you have sealed the part that was holding up best while the weakest line stays open to the weather.
This is also where a patio looks finished or doesn’t. A coated top with raw gray edges reads like a rug laid on concrete. A wrapped edge reads like the slab was always that color.
Seal the top and leave the edges bare, and you have protected the strongest part of the slab and left the weakest one open.
Which way the water goes
Every patio is poured with a fall, a slight slope that sends rain away from the house and off into the lawn. A good builder’s slab drops away from the back wall. Coatings are thin. They follow the shape of the concrete underneath, so the fall you have now is the fall you will have afterward.
That makes the walkthrough the moment to find out. Jimmy looks at where water sits after rain, which way the slab drains, and whether any section tips back toward the foundation. If one does, you hear it before anything is coated, because it is a concrete question first and a coating question second.
The joints matter for the same reason. Control and expansion joints are where a patio moves between summer and winter, and they are honored, kept open and sealed, never coated straight across. Bridge one and the coating simply cracks along it. More on how we build outdoors is on our patio flooring page.
Picking a blend against the siding
A patio is the one floor you look at from inside the house and from the yard, with siding behind it and grass around it. A blend that looks right on a chart can fight beige vinyl or disappear against a green lawn, and the only way to know is to see it there.

There are thirty one blends. The chart runs from Raven at the dark end through Lunar to Cookie on the warm side. Outdoors, the dark end gets hot in full sun and the warm end tends to sit comfortably with tan and beige siding, but we would much rather you decide with samples on the concrete, at the time of day you actually use the patio.
Whatever you pick, the topcoat is UV stable, so the color you chose in April is the color you still have in September. The Blandon patio page goes through the full outdoor build step by step.
Grills, bench feet and the outdoor season
Patios get lived on. The grill drips, chairs get dragged, kids bring half the lawn in on their shoes. On a sealed flake surface none of that soaks in. Grease wipes off the topcoat instead of staining the slab, and a dust mop plus warm water with a mild cleaner is the whole care routine.
The one thing we cannot control is the sky. Exterior jobs run from spring through fall, scheduled with the forecast in hand, and if rain arrives inside the window we move the date rather than gamble with it. Because the exterior calendar fills from spring, organizing it over the winter gets you the dates you want. If a pool sits next to the patio, the pool deck page for Blandon covers doing both in the same visit.
Before Jimmy comes to look
After the next heavy rain, watch where the water sits on the slab.
Walk around the patio and note which edges stand above the grass.
Leave the grill and benches where they normally live, so the blend gets judged in context.
Patio questions from around the township
Can you fix a patio that slopes toward the house?
Not with a coating alone. A coating follows the concrete under it and will not change the direction water runs. If part of your slab tips back toward the foundation, Jimmy will tell you at the walkthrough and explain the options before anything is decided. Better to hear that on day one than after the floor is finished and the first storm comes through.
Will flake get slippery when the patio is wet?
Not when it is specified for outdoors. On a patio we leave more of the chip standing than inside a garage, and the topcoat is chosen to keep that texture, so there is something for a wet shoe to grip. Too coarse is its own problem, rough underfoot and harder to sweep, so the texture is set to how the patio is really used.
Do the coated edges match the top?
Yes. The edges are ground and built with the same system and the same blend, so the color carries over the corner and down the face. Where the slab meets the soil you get a clean finished line. That is what makes the patio look like it was poured that color, instead of a coated top sitting on gray concrete.
A sound development slab is the best kind of patio to coat, as long as the edges and the falls get the same attention as the color. Other floors we coat across the township are listed on the Blandon service area page.
Have the patio looked at before spring fills up
Send a rough size and a photo of the slab from the back door. Jimmy returns calls within a business day and will set a time to come out with samples.
Call (484) 942-3219 or write to us here. Product made in the USA, PA HIC 177204.
Book a walkthrough